Baby for rubber boat type D solid stern:

1. The wheel is a polyurethane solid wheel with a diameter of about 260mm and a cross-section width of about 85mm.

2, the support is made of 304 stainless steel, the support square tube 38*25 wall thickness of 1.5mm, bolts, screws, pins and so on are also made of 304 stainless steel.

3. Net weight of stern wheel is about 5.3kg, after package weight is about 6KG, package size: 540*300*130MM.The packing case is standard export box.

4. The stern wheel is installed on both sides of the aft stern plate of the inflatable boat, which can be lowered and retracted freely.Easy to tow boats.Easy to disassemble and assemble, easy to carry.

Baby for rubber boat type D inflatable stern:

1. The wheel is inflatable, with a diameter of about 260mm and a cross-section width of about 80mm.

2, the support is made of 304 stainless steel, the support square tube 38*25 wall thickness of 1.5mm, bolts, screws, pins and so on are also made of 304 stainless steel.

3. Net weight of stern wheel is about 5.3kg, after package weight is about 6KG, package size: 540*300*130MM.The packing case is standard export box.

4. The stern wheel is installed on both sides of the aft stern plate of the inflatable boat, which can be lowered and retracted freely.Easy to tow boats.Easy to disassemble and assemble, easy to carry.

Stern wheel factory wheels and stents have been installed, to kiss you just need to put the bracket to the stern plate, installation requires a drill and a bit, the stern plate first eight holes, aim to support, self-locking nuts fixed with screws, note: stern plate and to the screw of the need to add form a complete set of 304 stainless steel gasket, prevent spinning.